Accessories

works very well
I used this tool to do electrical cut outs in a new dry wall installation. I discovered that even when using guide point bits designed for this work this tool has so much power that it will melt/cut right through the side of the plastic box if you aren't careful. It takes a little practice to develope the feel to use it on plastic boxes.

Since I lack the patience and or skill to use this on plastic boxes without cutting into them I built a metal cover plate that I install on the plastic box that permits me to quickly router the drywall without damaging the box. Once the hole is routered I just pop of my cover and move it to the next box.

I found that it also works great for doing the cut outs before the sheets are installed while blocked up on my cutting table if I mark the location and use the metal edge of my t-square as a guide. I start in the lower left corner and slide the flat side of the depth shoe along the square to the right to the second corner, I hold the tool stationary against the square and slide the square up along the drywall with the tool held stationary against the square to the opposite side of the cut out opening, to the 3rd corner. Then I slide the tool to the left along the square to the forth corner, then hold it stationary against the square and slide the square back down to the point of origin while holding the tool against the blade. This results in a perfect square or rectangular opening in much les time than doing it with a knife or drywall saw. It takes less time to do it than it does to describe it.

I have now also used it to cut out window openings in drywall on my cutting table using my t-square as a guide, it is a little slower than using a knife but it is also a lot less effort.

This is a good tool that does exactly what it is supposed to do. I don't know what else it could do any better. I can't wait to cut the circles for the can lights in the ceiling!

Fantastic Hole Cutter for even Better Price
This thing runs Amazing. i cut through 1/2 partical board with the included cheap bit in no time. it has a good circle guide, and the batteries are strong. the real question is how long it will last. for the price i paid it was cheaper than buying a 6" hole cutter, and has much more function than just that cut. i am pleased, and will buy another as a backup if the price goes lower again (i paid $20)